Naggura SWOP 502 Instruction Manual page 11

Operation Swop502
Motors controller
The Swop S502 is equipped with 4 engines.
Use the backrest inclination keys to tilt the bac-
krest up and down.
Use the legrest inclination keys to tilt the legrest
up and down.
The height of the bed can be adjusted too. To
lift the bed, simply push the UP button on the
hand switch. Once the desired height is achie-
ved, realease the button. To lower it, do the
same operation with the DOWN button. (Third
row of keys)
You can also adjust the whole inclination of
the bed downwards or upwards using the seat
inclination keys.
Foot controller
11
A foot controller is available as an option and
it can be ordered separately. You can adjust all
the 4 movements of the bed by means of the
foot controller.
In order to use both the hand controller and
the foot controller simultaneaously, you need
a branched cable and you must plug it into the
control box.
See instructions in picture below.
Connecting the foot controller
Locate the control box inside the table base
frame. Take the safety piece that locks the
conectors into each plug and disconnect the
cable HS.
Connect the branched cable in the plug named
HS. Place again the saftey piece to lock the
connectors.
Now you can connect the handcontroller and
the foot controller in the two plugs.
6
Instruction
Manual
Backrest
inclination
Legrest
inclination
Up &
Down
Seat
inclination
11