Table of Contents
Advertisement
LP150X501x-FNR
2014 06 19 V0.1
11.6
Resistive Touch Panel Integration Design Guide
Avoid the design that Front-case overlap and press on the active area of the touch-panel.
Give enough gap (over 0.5mm at compressed) between the front case and touch-panel to protect wrong operating.
Use a buffer material (Gasket) between the touch-panel and front-case to protect damage andwrong operating.
Avoid the design that buffer material overlap and press on the inside of touch-panel viewing area.
P.17
Copyright © 2014 FDT http:// www.fdt.com.tw, E-mail-
fdt@fdt.com.tw
This technical specification is subject to change without notice
Advertisement
Table of Contents
