Advertisement
Quick Links
It is the responsibility of the purchaser to examine and check the vanity for suitabilty
Once the vanity has been installed, no claims for damage or incorrect goods can be made.
Please check all goods for damage and notify point of purchase of any damage/missing products.
To ensure the longevity of the unit, no part should be never be dragged, stood on and
it is recommended that the drawer runners are covered to prevent dust blocking the runners.
2. Remove the top from vanity ensuring it is in a safe spot, where it cannot be damaged/marked.
3. Having established the position of the vanity on the wall, mark and drill the holes for your
plumbing fixtures (ie waste outlet, hot and cold water inlets)
4. Once it is level and square, fix the vanity to the wall using the correct fitting depending on your wall
(no fixing supplied). If using standard screws and star plugs, be sure to use the washers in order to
Position fixings as shown below:
K A D O
ASPECT VANITY
PRIOR TO INSTALLATION
A licensed tradesperson must install your Rifco vanity
and damage BEFORE installation.
INSTALLATION INSTRUCTIONS
1. Remove the drawer
Open the drawer about 80%
Place drawer in a safe spot.
No claims for damages will be recognised after installation.
Move vanity into position and ensure it is level and square.
This may require packing behind and/or below the vanity.
spread the load.
The number of fittings used to fix cabinet will depend on the size of
unit, your installer will know the suitable amount depending on the
The use of dyna bolts is recommended for masonry wall and fixing to studs in cavity walls.
It is not recommend to install wall hung vanities with toggle type fixing systems.
Plumbers, please ensure a copy of the installation instructions
is left with the end user for future reference
size of your cabinet.
It is recommended the following minimum;
Up to 900 width of vanity – 3 per row
900 to 1200 width of vanity – 4 per row
For wall hung vanities, it is essential the unit is fixed securely.
page 1 of 4
Pull upwards, not too
hard, you'll hear the click
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Reece KADO ASPECT Vanity
Summary of Contents for Reece KADO ASPECT Vanity
- Page 1 page 1 of 4 K A D O ASPECT VANITY PRIOR TO INSTALLATION A licensed tradesperson must install your Rifco vanity It is the responsibility of the purchaser to examine and check the vanity for suitabilty and damage BEFORE installation. Once the vanity has been installed, no claims for damage or incorrect goods can be made.
- Page 2 page 2 of 4 K A D O ASPECT VANITY 5. Connect the water supply lines and waste outlet. 6. Replace drawer back onto the vanity unit and make any necessary adjustments. Pull the runners all the way out Push all the way in until you and sit the drawer on top hear the click on both sides 7.
- Page 3 3) Is the largest opening force For standard vanity use, and recommended by Reece and Grass, the unit comes pre-set at setting 1. For the drawer to close properly, it must be opened by a distance of no less than 100mm from the closed position prior to attempting to close the drawer, otherwise the mechanism wont allow the drawer to close.
- Page 4 page 4 of 4 K A D O ASPECT VANITY CARE AND MAINTAINANCE The Aspect vanity is manufactured from water resistant materials but are not waterproof. Care must be taken to immediately dry any spillage or leakage of water. Please also ensure bathroom is well ventilated and out of direct sunlight for long periods of time. LAMINATE TIMBER TOP: Using a mild household spray wipe down the benchtop with a soft cloth.
Need help?
Do you have a question about the KADO ASPECT Vanity and is the answer not in the manual?
Questions and answers