Advertisement
3. Slide the square axle through the hole in
the clamping block. Slightly open the clamp-
ing block if necessary.
4. Repeat steps 1–3 to fit the other end of the
axle to the clamping block.
5. Adjust the clamping block on the axle
sleeve. The scales on the axle sleeve can
help. Tighten the knobs on both clamping
blocks.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 62638, 62639
Page 4
12
2021-1
Advertisement
