Advertisement
2. OPERATION INSTRUCTIONS
1. Turn on Power Switch (1)
2. Adjust and set preferred UHF transmitting module's channel.
•
Ajust : Turn (F) clockwise (you will hear a "click"), then LCD will turn on and show
the channel number, it means transmitting module is on. You can adjust the volume by
keeping turning (F) clockwise. (Vice versa, turn counterclockwise till you hear a click and
then LCD will show , after 2 to 3 seconds LCD will turn off . )
•
Set : Turn on transmitting module, LCD will show channel number such as . To adjust
channel number please hold on "SET" (D) for one second, then channel number in LCD
will start fl ashing like , press "channel selector" (E) button and adjust to the channel
number you want (1~16 or 1~96). Press "SET" (D) to fi nish your setting.
3. Wired microphone signal being transmitted via TX module
Press "MIC TX (3)" fi rst, if the red light underneath is on that means wired mic's
signal is successfully transmitted.
4. AUX IN signal being transmitted via TX module.
Press AUX TX (5) fi rst, if the red light underneath is on that means AUX IN signal is
successfully transmitted.
5. Stereo phone jack
Insert 6.3 mm earphone into earphone jack (13), adjust volume (12) and then you can
monitor AUX IN (16) signals.
4
Advertisement
