Panasonic CF-VEB343 Operating Instructions Manual page 8

Connecting/Disconnecting
5
While holding the latch to the right side, slide the
lever all the way back. (UNDOCK POSITION)
CAUTION
Do not slide the lever without holding the latch to
the right side.
6
After confirming that the expansion bus
connector of the port replicator is positioned so
that the computer can be docked, insert the front
corners of the computer and then press down
lightly on the rear corners onto the port replicator
E
guide pins.
7
Confirm that the lever has moved all the way to
the front. (DOCK POSITION)
CAUTION
• Do not attempt to make connections if there is any object between the computer and the port
replicator. Doing so could damage the computer and the port replicator.
• Do not attempt to move the port replicator when it is connected to the computer.
• If the computer malfunctions while the port replicator is attached, refer first to the
"Troubleshooting" section of the computer's "Operating Instructions". If you still are unable to
solve the problem, power off the computer, disconnect the port replicator, connect the AC
adaptor to the computer, and check to see if the computer operates normally. If the computer
operates normally when the port replicator is not attached, the port replicator may be
malfunctioning. Please contact Panasonic Technical Support.
8
Lever
Latch
(1)
(1)
Insert the left and right hooks
into the computer's locking
holes.
Lever
(2)