Table of Contents
Advertisement
Available languages
Available languages
Cleaning metal grease filters
The metal grease filters can be cleaned in hot detergent
solution or washed in the dishwasher. They should be
cleaned every 2 months use, or more frequently if use is
particularly heavy.
• Open the visor by pulling it.
• Remove the filter, pushing the lever towards the back
of the unit and at the same time pulling downward.
• Wash the filter without bending it, leave it to dry thoroughly
before replacing (if the surface of the filter changes
color over time, this will have absolutely no effect on
its efficiency).
• Replace, taking care to ensure that the handle faces
forward.
• Cleaning in dishwasher may dull the finish of the metal
grease filter.
• Close the visor.
Replacing Activated Charcoal Filter
The Activated Charcoal Filters are not washable
and cannot be regenerated, and must be replaced
approximately every 4 months of operation, or more
frequently with heavy usage.
• Open the visor by pulling it.
• Remove the Filter, pushing it towards the back of the
unit and at the same time pulling downward.
• Remove the saturated Activated Charcoal Filters, as
indicated (A).
• Fit the new Filters, as indicated (B).
• Replace, taking care to ensure that the handle faces
forwards.
• Close the visor.
Lighting unit
• Turn off electrical supply before replacing
bulbs, and make sure bulbs are cool to
touch before proceeding.
• Remove the snap-on lamp cover by
levering it from under the metal ring,
supporting it with one hand.
• Replace the lamp with a new one of the
same type, making sure that you insert
the two pins properly into the housings
on the lamp holder.
• Replace the snap-on lamp cover.
A
B
Gu10 self-ballasted led
lamps – listed in ac-
cordance with
ul 1993/nmx-
j-578/1-ance/
csa c22.2 No.
1993
11
Advertisement
Table of Contents
