Troubleshooting - TGA BREEZE S Operating Instructions And Owner's Handbook

• Repairs relating to electrical or mechanical
components should be performed by your
Breeze dealer only.
• Clean upholstery using a damp cloth and
a little soap. Do not use abrasive cleaners
as this will damage the coating. Upholstery
can be damaged by chemical cleaners.
Ultraviolet light can also reduce the life
of the upholstery coating material. This is
a normal ageing process and cannot be
guaranteed (see exclusion in Warranty Terms
section).
• The bodywork on your Breeze can be
lightly washed with clean soapy water. Car
polish can be used to keep the paint and
bodywork in pristine condition. Do not use
abrasive cleaners or strong detergents as
this will damage the surface and may cause
fading of the colour.
CAUTION: Do not hose down your Breeze.
Water could be forced into the electronics
and cause permanent damage.
DO NOT store your Breeze in damp
conditions. This may affect the electronics if
left for very long periods of time.
Servicing of drive electronics/charger
should only be carried out by a TGA service
dealer. These units are sealed and should
not be opened. Broken seals will void your
warranty.
Do not drive your Breeze in extreme
weather conditions i.e. very heavy rain. Do
not drive through deep water. This could
damage the main electronic controller, or
other electronics.
If the motor brakes are functioning correctly,
you will not be able to push your machine
when it is switched off or switched on with
the speed control throttle in the neutral
position.If your machine can be pushed
when as described above, the motor
brake(s) may be faulty. Do not use the
scooter and contact your dealer.

Troubleshooting

The Breeze will not start:
• Check it has not gone into sleep mode.
• Make sure that the key switch is turned on.
If it is, the battery condition gauge will be
operating. If it is showing empty – recharge
batteries.
• Check overload switches.
• Check brake release is not in freewheel
position.
• Make sure the battery charger is not
connected, this will prevent drive.
The battery condition gauge fails to
operate when the key switch is on:
• Make sure the battery charger is not
connected, this will prevent drive.
• Check the battery connectors, battery
terminal condition.
• If none of the above contact your Breeze
dealer.
The Breeze does not slow down or the
variable speed control does not work:
• Turn off the power on key switch.
• Inform your authorized TGA dealer.
The Breeze stops and will not restart:
• Turn off the power key. Check the overload
switch, which can be reset by simply pushing
the button in. Turn power key back on.
CAUTION: If you find for any reason your
Breeze does not reduce speed when you
let go of the speed control lever, use the
manual brake on the handlebars. If this fails
to stop you, switch your Breeze off with the
ON/OFF key. The parking brake will activate
immediately and stop your Breeze. Beware
the machine will stop very suddenly so brace
yourself with the handlebars and sit back on
your seat.
The Speed Control Lever is also fitted with
a panic sensor which is activated if the lever
is pulled in hard against the handlebar. If
this happens all power to the motor will
10