Add-A-Bathroom framing Installation Manual

Unit 1, 18 Francis Rd. Wingfield. South Australia. 5013

Ph: 1300 559 121

info@addabathroom.com.au

www.addabathroom.com.au

Installation guide for Add-A-Bathroom assembled bathrooms.

Please read the entire guide prior to commencement of installation.

Note that this guide is provided for general information purposes only and should not be relied upon without

professional advice about your personal situation and installation requirements. As this guide does not take

personal circumstances or local regulations into account and as any installation is beyond the control of Add-

A-Bathroom, no responsibility is accepted nor warranty implied by Add-A-Bathroom (or its affiliated

entities) by the publishing or use of this guide.

Add-A-Bathroom bathrooms are manufactured and assembled in our modern production facilities and are

supplied ready for installation.

Follow this simple guide and your Add-A-Bathroom bathroom should give you many years of trouble free

service. No leaks, no cracks, no maintenance. If you have any queries, please call us on 1300 559 121.

No specialised tools are required to install an Add-A-Bathroom flat pack bathroom. Installation of a

bathroom usually requires 2 competent people.

All plumbing and electrical work must be performed by appropriately licensed contractors.

The bathrooms are supplied fully assembled, and will have been fitted with a combination of pipe-work,

electrical, bathroomware and internal accessories as per individual order. Before ordering, ensure that there is

sufficient access (and labour) so the assembled bathroom can be manoeuvred to the installation site. (If this

presents difficulty, the pre-fitted bathroom can be supplied disassembled as a 'flat pack', ready for on-site

assembly. Please contact Add-A-Bathroom for more details).

Before commencing installation open packaging and ensure all items are correct and in acceptable condition.

No claims regarding damage or missing components can be entertained after assembly commences.

Clean and maintain your new Add-A-Bathroom bathroom with domestic grade non-abrasive cleaning agents.

Walls may be polished with automotive or marine polishes suitable for use on fibreglass. Ensure polishes,

silicone washes, waxes and the like are kept away from any bathroom floor as such products may be slippery.

No warranty is expressed or implied by the publication or use of this guide. Page 1 of 4

Table of Contents

Need help?

Do you have a question about the framing and is the answer not in the manual?

Page 1 Add-A-Bathroom bathrooms are manufactured and assembled in our modern production facilities and are supplied ready for installation. Follow this simple guide and your Add-A-Bathroom bathroom should give you many years of trouble free service. No leaks, no cracks, no maintenance. If you have any queries, please call us on 1300 559 121.
Page 2 This will have been done as required for factory fitted accessories. Where safety grab rails, seats etc are required to be fitted, contact Add-A-Bathroom as these may require additional measures, specific to the item. • If your bathroom was not purchased with an electrical kit, have your electrician fit electrical at this time.
Page 3 This is especially important adjacent to the door opening. Where it is not possible to install the framing tight against the walls, cut short lengths of timber and screw to the framework as braces. The braces should also be screwed or glued to the flanges of the bathroom, and glued to the back of the bathroom’s walls.
Page 4 Product from the Add-A-Bathroom facility. To make a claim under this warranty, you must contact Add-A-Bathroom on 1300 559 121. All expense of claiming under the warranty will be borne by the person making the claim.