Advertisement
S A F E T Y N O T E S
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
Children as well as adults with physical, mental and ⁄or
sensoric impairments must not use this product without
proper supervision. Persons under the influence of
alcohol or drugs are prohibited from using this product.
Do not allow the streams of the shower touch sensitive
body parts (such as your eyes). An adequate distance
must be kept between the shower and you.
The product may not be used as a holding handle. A
separate handle must be installed.
The hot and cold supplies must be of equal pressures.
I N S T A L L A T I O N I N S T R U C T I O N S
⁄ Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
⁄ The pipes and the fixture must be installed, flushed and
tested as per the applicable standards.
⁄ The plumbing codes applicable in the respective
countries must be observed.
⁄ The mesh washer must be insert to protect the shower
against incoming dirt by pipework. Incoming dirt leads
to defects or⁄and can damage parts of the shower;
such caused faults voids all liability and guarantee
claims.
F A U L T
⁄ Insufficient water
⁄ Mixer stiff
⁄ Mixer dripping
⁄ Water escaping in area of swivel
spout
⁄ Spout temperature does not
correspond with temperature set
⁄ Instantaneous heater didn't work
A S S E M B L Y (see page 04 )
T E C H N I C A L D A T A
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Thermal disinfection:
The product is exclusively designed for drinking water!
S Y M B O L D E S C R I P T I O N
C A U S E
⁄ Shower filter seal dirty
⁄ Cartridge defective, calcified
⁄ Cartridge defective
⁄ O-ring defective
⁄ Hot and cold supplies are reversed
⁄ Shower filter seal dirty
⁄ Flow limiter in handshower isn't re-
moved
(1 MPa = 10 bar = 147 PSI)
Do not use silicone containing acetic acid!
Hot and cold supplies are reversed
(see page 11 )
M A I N T E N A N C E (see page )
D I M E N S I O N S (see page 06 )
F L O W D I A G R A M (see page 07)
S P A R E P A R T S (see page 15 )
XX = Colors
00 = Chrome Plated
34 = Brushed Black Chrome
99 = Polished Gold-Optic
S P E C I A L A C C E S S O R I E S
(order as an extra)
⁄ extension 60 mm #93882000 (see page 15 )
C L E A N I N G (see page 08 )
O P E R A T I O N (see page 07)
R E M E D Y
⁄ Clean filter seal between shower and
hose
⁄ Exchange cartridge
⁄ Exchange cartridge
⁄ Exchange O-ring
⁄ Install function block turned through
180º (see page 11 )
⁄ Clean filter seal between shower and
hose
⁄ Remove flow limiter
0 3
EN
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
max. 60°C
70°C ⁄ 4 min
Advertisement
