IMPORTANT: RETAIN FOR FUTURE REFERENCE, READ CAREFULLY
Safety Precautions
Read all instructions before assembly and use of the adaptor. Keep instructions for future use.
IMPORTANT
This adaptor is designed for Hipod / Unity Car Seat; to be used with most umbrella fold strollers including the
following:
Maclaren stroller models: Daytripper, Triumph, Quest, Vogue and Techno XLR
Childcare stroller modes: Lunar / Lunar XT / Lunar XLR and Alto / Alto XT / Alto XLR
bebe care stroller models: Mira
This adaptor is designed to be mounted on both 16mm and 19mm diameter front tubes of the umbrella fold
stroller.
1. When assembling the
adaptor to 16mm diameter
tubes, engage the bracket
onto the inside tab.
3. Always ensure the safety strap on the adaptor is closed by applying the press stud.
WARNING
DO NOT TRY TO ENGAGE THE BRACKET ONTO THE INSIDE TAB WHEN FITTED TO 19mm DIAMETER
TUBES
ALWAYS CLOSE THE SAFETY STRAP
Assembly Contents
Bolt and Nuts x4
This product has been designed and manufactured to comply with Australian Safety Standard AS 2088:2009.
Distributed in Australia by CNP Brands, 20 Calarco Drive, VIC, 3030
Customer Service 1300 667 137 www.cnpbrands.com.au
Distributed in New Zealand by Wainhouse Distribution, 2-6 Argyle St,
Morningside, PO Box 41-014, St Lukes, Auckland, New Zealand
Customer Service: 0800 567 5000 helpline@wainhousedist.co.nz
STROLLER HIPOD / UNITY
TO BE REPLACED WITH PHOTOS
Left adaptor
Adaptor Model # 121315-002
2. When assembling the
adaptor to 19mm diameter
tubes, engage the bracket
onto the outside tab.
Right adaptor
Metal frame