Sunrise Medical Sedeo Lite Assembly Instructions Manual page 4

Mounting the manually elevating legrest
Preparation
Note! Switch off the wheelchair via remote control.
Instructions
Note! Suitable work area required!
• Mount the legrest mounting bracket to the seat support
frame.
• Secure the legrest in its upper position.
• Release the footplate fi xing screw and lower the
footplate to remove it from the legrest.
• Unscrew the lower clamp of the damper unit.
• Position the clamp nuts in the legrest profi le and attach
the calf plate to the clamp nut.
• Adjust the calf plate height to the desired position,
tighten the clamp nuts.
• Remount the lower clamp of the damper unit.
• Reposition the footplate and tighten the fi xing screw.
Adjust the calf plate depth to the desired position.
• Adjust the calf plate inwards/outwards to the desired
position. Lower the legrest into the tube of the mounting
bracket, holding the footplate outwards. Swing the
legrest inwards to lock it in position.
Note! Make sure the locking pin falls in place (with a 'click')
and secures the legrest from becoming detached.
Note! If locking fails: Adjust the screw from the locking
mechanism.
Relevant article numbers
1018305 Manually elevating legrest set with calfplates SW
42-46
1018291 Manually elevating legrest RHS SW 42-46 cm
1018294 Manually elevating legrest LHS SW 42-46 cm
1018293 Manually elevating legrest RHS SW 54 cm
1018295 Manually elevating legrest LHS SW 50 cm
1018292 Manually elevating legrest RHS SW 50 cm
1018296 Manually elevating legrest LHS SW 54 cm
Tools used
4/5
T30
EN
13