Subscribe to Our Youtube Channel
Related Manuals for Aero-Spa Aero-pool
Summary of Contents for Aero-Spa Aero-pool
- Page 1 Installation Guide For additional assistance please contact us at: Technical Support 877-226-8111 info@aero-spa.net © 2022 Aero-Spa®, LLC REV C...
- Page 2 2 PPM residual chlorine sanitizer in the water at all times. The best industry practice will minimize the possibility of cross contamination; however; will not eliminate possibility. © Copyright Aero-Spa®, LLC 2017 P/N102757 rev B...
-
Page 3: Important Safety Instructions
Read and follow all instruction. Never operate Aero-Pool equipment indoors. Do not use pool for 30 minutes after the Aero-Pool unit has operated. Never inhale ozone exhausted by Aero-Pool unit. Follow all electrical installation instructions in this installation guide. -
Page 4: Equipment Identification
Please note that your product may vary from photos in this installation guide. Aero-Pool Generator Sintered Diffuser 20ft Ozone Tube Model: AP 1000 DESCRIPTION Aero-Pool Generator 20ft – Ozone Tube Sintered Diffuser Figure 1: Equipment Identification © Copyright Aero-Spa®, LLC 2017 P/N102757 rev B... -
Page 5: Equipment Setup
For best results it is highly recommended that the pool be thoroughly cleaned to remove residual dirt and contaminants prior to installation of the Aero-Pool system. Set the equipment on a level solid spacer block that is at least 2 –... - Page 6 Figure 3: Ballast Installation 2. Connect the free end of the 20’ ozone tube to the fitting exiting the underside of the Aero-Pool unit. Secure with provided cable tie. 3. Lower the sintered diffuser into the pool in an area that is 7’...
-
Page 7: Grounding Requirements
Only if required, obtain a UL outdoor rated extension cord. Never locate the Aero-Spa generator closer than 10’ from the hot tub. In the event of a power outage, the GFCI device will need to be reset manually. -
Page 8: Maintenance And Care
The diffuser stone can be cleaned with a 3% hydrogen peroxide solution or muriatic acid. Fill & Start-Up Recommendations Our customers have been using the Aero-Pool system as the primary water treatment process for years with limited harsh chemicals. Because we cannot control how your pool is... -
Page 9: Troubleshooting
Reset circuit breaker at house fuse panel. 2. Verify ozone tube is not broken, pinched, or disconnected 3. If these steps do not solve the problem call Aero-Spa, LLC Water is cloudy A condition typically associated with excess organic particulates from oils and soaps. - Page 10 If there is more than a few drops proceed to step 2. below 2. Turn off all power by unplugging Aero-Pool from the 120 volt power outlet. Remove the sintered diffuser from the pool and lay it on the ground at a lower elevation than the generator.
-
Page 11: Manufacturer's Limited Warranty
If during the first ninety days you are not satisfied with the water quality in your hot tub or pool you can return the Aero-Spa™ product to us for a refund. All other unused products and accessories returned are subject to a twenty-five percent restocking fee and must be returned within fourteen days of purchase. - Page 12 W300 N7706 Christine Lane, Hartland, Wisconsin, 53029, visit our website at www.aero- spa.net or e-mail us at info@aero-spa.net. If Buyer is making a warranty claim, please provide a description of the nature of the problem. Alternatively, call the following toll-free number to obtain further warranty instructions: 1-877-226-8111.
Need help?
Do you have a question about the Aero-pool and is the answer not in the manual?
Questions and answers