3.2
AMI BIOS Setup
The AMI BIOS ROM has a pre-installed Setup program that allows users to modify basic
system configurations, which is stored in the battery-backed CMOS RAM and BIOS
NVRAM so that the information is retained when the power is turned off.
To enter BIOS Setup, press <Del> or <ESC> immediately after powering on the system.
The function for each interface can be found below.
Main – Date and time can be set here. Press <Tab> to switch between date elements
Advanced – Configure settings for system hardware
Chipset – For host bridge parameters
Boot – Enable/ Disable quiet boot option and set boot priorities
Security – The setup administrator password can be set here. Secure Boot settings can
be configured here.
Save & Exit –Save changes and exit the program
Chapter 3 – AMI BIOS Setup
51