Table of Contents
Advertisement
2.3.3
DO Port Architecture (CON1)
When the PC is powered up, all DO port (CON1) operations are disabled. The
RESET\ signal controls the enable/disable signal for the DI port. Refer to Sec. 3.3.1
for more information about the RESET\ signal.
• The RESET\ is in Low-state
all DO operations are disabled
• The RESET\ is in High-state
all DO operations are enabled
The power-up states are as follows:
• All DO operations are disabled
• All output latches are cleared to Low-Level
RESET\
clear
Data
CON1
input
Latch
Clock input
D/O buffer CKT
OME-PIO-D56/PIO-D24 User Manual (Ver.2.1, Oct/2003, PPH-005-21)
---- 10
Advertisement
Table of Contents
