GE UVW7241SNSS Owner's Manual & Installation Instructions page 9

TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Gather the required tools and parts before starting
installation. Read and follow the instructions
provided with any tools listed here.
Tools needed
• Level
• Drill with 1-1/4" (3.0 cm), 1/8" (3.2 mm), and 5/16"
(7.9 mm) drill bits
• Pencil
• Wire stripper or utility knife
• Tape measure or ruler
• Pliers
• Caulking gun and weatherproof caulking
compound
• Vent clamps
• Jigsaw or keyhole saw
• Flat-blade screwdriver
• Metal snips
• Phillips screwdriver
• Metric hex key set
For non-vented (recirculating) installations, you will
also need:
• 6" (15.2 cm) dia. round metal vent duct - length
required is determined by ceiling height.
49-2000742 Rev. 0
Installation Preparation
PARTS SUPPLIED
Remove parts from packages. Check that all parts
are included.
• 120 V power cord with 3 prong plug
• Hood canopy assembly with blower, vent
transition, light bulb and canopy glass already
installed
• Metal grease filter
• Vent cover support bracket
• Mounting template
• 2-piece vent cover
• 4 - 4 x 8 screws
• 6 - 5 x 45 mm mounting screws
• 2 - 8 x 40 mm wall anchors
• 4 - 10 x 50 mm wall anchors
9