Planning Installation; Tools Required - Home Depot VISSANI HVUF11SLF Use And Care Manual

PLANNING INSTALLATION

□ The refrigerator should be located on a completely flat surface.
□ Leave about 2 to 4 inches (5-10 cm) between each side of the appliance and the wall.
□ Leave 12 inches (30 cm) between the top of the appliance and the ceiling.
□ Choose a location which is not exposed to sunlight, high temperature or humid, as humidity may cause stain.
□ The appliance can be adjusted by turning its two legs in the front of the bottom panel when it is unstable. Turning
them in the clockwise direction can raise the refrigerator.
□ The location should be firm and flat. An unsecure position may cause noise and vibration. The noise may be
increased if the floor is not firm. Put a sheet under the appliance to solve the heat emission if you need to locate it
onto a carpet.
□ Make sure the adjustable legs are firm on the floor, and set the appliance slope backward slightly to keep the doors
closed tightly.
□ Make note of the position of the contents and retain packaging for future packing and moving.
□ Do not lift by the door handle when moving the appliance.
□ Do not tilt the appliance more than 45 degrees.
□ Avoid strong vibration and collision.

TOOLS REQUIRED

Medium-sized
Phillips
screwdriver
Small -sized
Phillips
screwdriver
4
Allen wrench