Table of Contents
Advertisement
HELPFUL TIPS
Shaving Ice
•
For best results, let ice sit in a separate bowl or container for 5-10 minutes before
putting in Ice Shaving Chamber. Ice should be slightly melted before shaving.
•
The Pitcher is able to hold more liquid than the fluid ounce measurements
allow, but has been marked to prevent spillage resulting from ice shaving
volume. If using the Ice Shaver, make sure to fill the Pitcher with no more
than 24-ounces of liquid. Exceeding this amount will result in spillage.
•
Prior to each use, make sure that Blade Cap has been
tightened for optimal shaving results.
Odor
As with most modern blending appliances, this unit has a high RPM electric
motor. It is common for the motor to emit a slight graphite or burning odor
for the first few uses. After the first few uses, the odor will go away.
Location of Water Reservoir and Cord
The Water Reservoir and cord are located at the back of the Ice Shaving Chamber.
CLEANING & MAINTENANCE
1.
After using your ICE SHAVING BLENDER, disconnect from electrical
outlet. Remove plug by gripping the plug body and pulling out of
the outlet. Never yank or twist cord to unplug the unit.
2.
Thoroughly wash the clear Pitcher and Pitcher Lid, Blending Blade with
Rubber Washer, Ice Tray, Ice Chamber Lid, and Water Reservoir in warm,
sudsy water and thoroughly dry. DO NOT put the Motor Base in water.
When needed, use a damp, non-abrasive cloth to wipe exterior.
3.
Once washing and drying is complete, reassemble your ICE SHAVING BLENDER.
Wind the cord and return to the convenient storage location at the back of
the Motor Base. Now your ICE SHAVING BLENDER is ready to use again.
(continued on next page)
7
Water Reservoir
Cord Location
Hide quick links:
Advertisement
Table of Contents
