ProFlow PFE-HC7110BK Installation Manual

Fan Control Module
Harness with Push in Probe OR Thermostat
Blue Butt Connectors
Blue 5/16" Ring Terminal
Blue #10 Ring Terminal
Blue Wire Tap Connector
Red Butt Connector
12 Gauge Red Wire
4" Wire Ties
WARNING: PLEASE READ ALL INSTRUCTIONS BEFORE PROCEEDING. PROFLOW WILL NOT BE
RESPONSIBLE FOR ANY DAMAGE AS A RESULT OF THE INCORRECT INSTALLATION OF THIS
PRODUCT. IT IS RECOMMENDED THAT A QUALIFIED AUTOMOTIVE TECHNICIAN PERFORMS THIS
INSTALLATION.
Control Module Installation
1. Choose an appropriate location to mount the relay. Preferred location will be near the
battery and where the thermostat will be located. Do not mount next to high heat
sources such as near exhaust housings, etc.
2. Use the modules mounting surface as a template to find and mark the mounting holes.
Drill 4x 5/32" holes in the correct locations.
3. Use the supplied screws to secure the unit.
Thermostat Installation
Thread-in Thermostat
1. Locate a 3/8" NPT port either on the radiator, water neck, intake manifold or cylinder
head.
2. Using teflon tape, thread the 3/8" theromstats into the desired location.
Probe Thermostat
1. The thermostat probe must be inserted into the core of the radiator. The best location
for the probe will be near the inlet of the radiator, in between the fins.
2. The probe should be secured tightly in between the radiator fins (full width of radiator).
EMAIL: sales@proflow.com.au
PHONE: 1300 879 879
Installation Manual
Electric Fan Controller Kit
PFE-HC7110BK / PFE-HC7111BK
Included Items QTY
1
1
2
1
1
1
1
1
4