Advertisement
INSTALLATION
WARNING:
The TH724 must only be installed by a licenced electrician.
Do not exceed 10AMP total.
Ensure the appliance controller is fixed/installed onto a flat surface
THE REMOTE
Selected
Channel On
All Channels Off
Channels 1-6
ADDING A FIRST REMOTE
1.
Select Channel 1 on the
remote by using the
select button.
2.
Insert a paperclip into
the learn hole on the back of
the remote (Next to the screw)
1
INPUT: 240VAC 10A 50Hz
OUTPUT: 2X 240VAC
MAX LOAD 10A 2400 Watts RESISTIVE
MAX LOAD 8A @ 0.5 Pf INDUCTIVE
ELECTRICIAN
N
E
A
A1 A2
INSTALL ONLY
INPUTS
OUTPUTS
Change Channel
Selected
Channel Off
3.
The Appliance Controller
will beep four (4) times to indicate
successful pairing.
ADDING A SECOND REMOTE TO THE APPLIANCE CONTROLLER
Select channel 1 by pressing
2.
Insert a paper clip pin into
1.
"Select" on both the master and
the reset hole at the back of
secondary remotes.
the master remote.
M
S
M
S
M
= Master Controller (already Paired)
S
= Second Remote (to be paired)
ALL ON/OFF FUNCTION
Swipe BACK of remote to the
right-hand side of the Power Point
to turn ON or OFF both Appliances
PAIRING TWO APPLIANCE CONTROLLERS
TO ONE REMOTE
1.
Ensure the remote is
2.
Isolate appliance controller 1 by
already learned to appliance
cutting the power from the mains.
controller 1 and all remotes
have been deleted from
appliance controller 2.
3.
Select Channel 3 on the
4.
remote by using the "select"
the reset hole at the back of
button.
the remote.
2
3.
The appliance controller
will begin to beep. Press the 'ON' (^)
button on the second remote.
S
M
4.
The appliance controller
will beep four (4) times to
indicate successful pairing.
1.
Hold the back of the remote
to the right hand side of the appliance
controller for 10 seconds.
10
sec
2.
The appliance controller will have a
continuous tone then beep 4 times
to indicate completion of deletion.
1
OFF
Insert a paper clip pin into
5.
The appliance controller
will beep four (4) times to
indicate successful pairing.
2
2
ON
Advertisement
