Raddy RF760 Operation Manuallines page 24

RF760 Full-Band Radio
If the SQ OFF is not needed, when you short press [SET] for the
second time and the SQ (SQ.ON.01~SQ.ON.09) flashes, please
short press (MODE) until (SQ.OFF.00) is displayed. At this time,
the SQ OFF will be closed (Note: the SQ OFF is set to adjustable
9 levels and the level can be selected according to actual
demands.)
14.6.3 Short press [SET] for the third time to enter the ATT
state and the (NORMAL) mode will be displayed. (DX) or
(LOCAL) display will flash. Then, short press [MODE] to select
(DX) or (Local) settings. After that, short press [SET] to confirm
that. Then, (ATT) (DX) or (LOCAL) stops flashing. (DX) or
(LOCAL) will exit if there is no operation within five seconds and
the work will be switched to be the current default setting.
14.7 UBD (Customized Receiving) Status:
14.7.1 Short press [SET] key for the first time. When (BW)
flashes, short press [MODE] key to set the bandwidth to be
1.70KHz, 4.50KHz, 3.75KHz and 2.50KHz.
14.7.2 Short press [SET] for the second time, the SQ
(SQ.OFF/ON.00) flashes. Then, short press [MODE] to select
SQ levels of (SQ.ON.01~SQ.ON.09).
If the SQ OFF is not available, please short press [SET] for the
second time. When SQ (SQ.ON.01~SQ.ON.09) flashes, short
press (MODE) to select (SQ.OFF.00) to turn off the SQ/NOISE
function.
14.7.3 Short press [SET] for the third time to enter ATT state
and (Normal) will be displayed. (DX) or (LOCAL) display will
flash. Then, short press [MODE] to select (DX) or (LOCAL)
settings. After that, short press [SET] to confirm them. Then,
(ATT) (DX) or (LOCAL) stops flashing. (DX) or (LOCAL) will exit
if there is no operation within five seconds and the work will be
switched to be the current default setting.
22