Raddy RF760 Operation Manuallines page 15

11. Operation for menu/clock setting [SET]:
11.1 Set time operation: In the shutdown state, long press [SET] for
two seconds and then short press [SET] and short press " , " to
start the clock setting (refer to details in 8.1).
11.2 Under the power-on state, start functions of the main menu
(refer to Operation Introduction 14 for details)
11.3 In WX band, long press [SET] to activate ALERT alarm and the
"SCAN" symbol flashes. Long press [SET] again to exit the Alert
function.
Note: SCAN indicates that WX is in the state of silent detection of
NOAA Alert state. If there is an Alert signal, sound or alarm will be
given out.
12. Rotary [flying shuttle] button:
Power-on state: Rotate the flying shuttle to adjust frequency display bit
values. When values are adjusted, the corresponding " " flashes. Short
press [STEP] to select the needed STEP value. Rotate the flying shuttle to
quickly select the desired frequency points.
13. Mode selection [MODE]:
13.1 In power-on state, press [SET] to start the main menu and short
press [MODE] to select and switch corresponding sub-menu
functions.
13.2 In short wave (SW) & super-high frequency (VHF) & aviation
(AIR) band, non-menu mode; short press [MODE] key to switch
meter band functions.
13.2.1 In the short-wave (SW) receiving state, short press
[MODE] to switch the meter band, and the frequency points are:
3.20000MHZ, 3.75000MHZ, 3.90000MHZ, 4.75000MHZ,
5.73000MHZ, 7.10000MHZ, 9.25000MHZ, 11.50000MHZ,
13.57000MHZ, 15.03000MHZ, 17.48000MHZ, 18.90000MHZ,
21.45000MHZ, 25.67000MHZ.
13
RF760 Full-Band Radio