Download Print this page

Sharp EL-6052 Service Manual page 2

Advertisement

PARTS LIST
No.
PARTS CODE
1
2
3
4
Battery Replacement
Battery used
Type
Lithium battery
Improper replacement of the battery may change or lose the
memory contents.
Be sure to write down any important information stored in the
memory before replacing the battery.
1. Precautions
Since improper use of the batteries may cause leakage or explosion,
strictly observe the following instructions.
Insert the battery with positive side (+) correctly facing up.
Never throw battery into a fire because it might explode.
Keep battery out of reach of children.
Because the battery in the Organizer was installed at the factory, it may
become depleted before the specified expiration time is reached.
2. Battery Replacement
If the display becomes dim and difficult to read, immediately replace the
battery with a new one. Continued use lf the Organizer with an exhausted
battery can alter or clear the memory contents.
Make sure the power is turned off before replacing the battery.
OFF
Do not press
until the battery replacement procedure is
ON
completed.
Do not use a metalic object to pry out the battery. The Organizer
will be subjected to an electrical shock and all the memory con-
tents will be cleared.
Complete the replacement of the battery within 1 minute, other-
wise all the memory contents may be cleared.
OFF
1. Press
to turn the power off.
ON
2. Loosen both screws and remove the battery
holder cover on the back of the unit.(Fig. 1)
3. Remove the exhausted battery by prying
it out from the right holder with the corner of
the holder cover.(Fig 2)
4. Install a new battery with the positive side
(+) facing up into the right holder. (Fig. 1)
Do not install the battery into the left
holder. It should be empty.
5. Replace the holder cover and secure it with
the screws.
OFF
6.Press
to turn the power on.
ON
If nothing appears on the display, press the RESET switch.
PRICE
NEW
RANK
MARK
AE
AD
AE
AE
AE
AE
AE
AE
AE
AE
Model
Quantity
CR2025
1
Leave
empty
Fig.1
Leave
empty
Fig.2
PART
RANK
N
D
Battery cover
N
C
Screw
N
D
Manual (ENGLISH)
N
D
Manual (GERMAN)
N
D
Manual (FRENCH)
N
D
Manual (SPANISH)
N
D
Manual (ITALIAN)
N
D
Manual (CHINESE)
N
D
Manual (ARABIC)
N
D
Chinese label
When "RESET?" is displayed, press any key other than SHIFT
ENTER . Pressing SHIFT
tents.
7. Set the clock.
Note)
Packing form
FORM
Blister
Universal
CAUTION FOR BATTERY REPLACEMENT
(Danish)
Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering.
Levér det brugte batteri tilbage til leverandoren.
(English)
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the equipment manufacturer.
Discard used batteries according to manufacturer's instructions.
(Finnish)
Paristo voi räjähtää, jos se on virheellisesti asennettu.
Vaihda paristo ainoastaan laitevalmistajan suosittelemaan
tyyppiin. Hävitä käytetty paristo valmistajan ohjeiden
(French)
Il y a danger d'explosion s' il y a remplacement incorrect
de la batterie. Remplacer uniquement avec une batterie du
même type ou d'un type recommandé par le constructeur.
Mettre au rébut les batteries usagées conformément aux
(Swedish)
typ som rekommenderas av apparattillverkaren.
COPYRIGHT
electronic, mechanical, photocopying, recording, or otherwise,
without prior written permission of the publisher.
DESCRIPTION
ENTER clears all the memory con-
SPEC
Country
U1C
SEC, LAG, MEXICO, SECL
LL1
SUK, SCA, STCL
LN0
SEIS, SEES, SEZ, SEF
LM4
SEEG, SEA, SRS, SRSSC
LD0
SRH
LO0
SEMF, Agent
ADVARSEL !
Udskiftning må kun ske med batteri
af samme fabrikat og type.
Caution !
VAROITUS
mukaisesti.
ATTENTION
instructions du fabricant.
VARNING
Explosionsfare vid felaktigt batteribyte.
Använd samma batterityp eller en ekvivalent
Kassera använt batteri enligt fabrikantens
instruktion.
1999 BY SHARP CORPORATION
All rights reserved.
Printed in Japan.
No part of this publication may be reproduced,
stored in a retrieval system, or transmitted.
In any form or by any means,
SHARP CORPORATION
Information Systems Group
Quality & Reliability Control Center
Yamatokoriyama, Nara 639-1186, Japan
1999 June Printed in Japan
(for BATTERY COVER)
[except LN0]
[LN0, LM4]
[U1C,LM4, LD0 ]
[U1C, LM4]
[LN0, LM4]
[LD0, LO0]
[LD0, LO0]
[LD0]

Advertisement

loading