Advertisement
To avoid a hazard due to instability of
the appliance, it must be fixed in
accordance with the instructions:
1. Use 13 mm screw to fix the fixing
bracket on the middle of bottom
cover.
2. Drill out a screw hole(6 mm) on the
floor.
3. Insert a screw anchor (wall plug)
into the drilled hole.
4. Move water dispenser, Align fixing
bracket hole with screw hole of the
floor
5. Put the 25mm screw into the screw
hole of fixing bracket.
6. Tighten the screw.
Install water bottle
1. Open dispenser door.
2. Place probe assembly on probe
hanger.
3. Place fresh bottle outside of
cabinet.
4. Remove the entire plastic cap from
top of bottle.
5. Clean outside of new bottle with a
cloth.
6. Place probe into bottle.
7. Slide collar down until it clicks in
place.
8. Push head down until tubes hit
bottom of bottle.
9. Slide bottle into cabinet and close
door.
7
Head
Collar
Head
Collar
Provide electricity
Plug cord into a properly grounded wall outlet.
At this time the pump will begin to move water from the bottle to the hot and
cold tanks. It will take up to 12 minutes to fill the tanks for the first time. During
this period the pump will run continuously. This is normal.
How to use
Activate heating and cooling
This unit will not dispense hot or cold
water until the switchers are activated.
To activate, push top side of power
switches in to start heating and
cooling water.
- If you do not want to heat water,
push bottom side of red switch in.
- If you do not want to cool water,
push bottom side of green switch in;
Dispensing water
This unit has been tested and sanitized prior to packing and shipping. During
transit dust and odors can accumulate in the tank and lines. Dispense and
dispose at least one quart of water to prior to drinking any water.
Attention
Sometimes when water is dispensed for more than 2 minutes, the pump fails to
take the necessary amount of water, and gets block, in this case the lack of
water indicator light on control panel will turn on. If this happens, just open the
cabinet door, then close it, and wait for 2 minutes, then the dispenser will
return to dispense water.
When the bottle is empty, replace it with a new bottle. (see instructions of how
on page 10).
8
Advertisement
