Advertisement
X"
Power Connector (20/2 Gauge Wire)
LLED8200-PC (33" Standard)
LLED8200-PC-X (X = Specify Length)
X"
Power Connector Black (20/2 Gauge Wire with Black Jacket)
LLED8200-PC-BK (33" Standard)
LLED8200-PC-BK-X (X = Specify Length)
X"
Power Connector White (20/2 Gauge Wire with White Jacket)
LLED8200-PC-WH (33" Standard)
LLED8200-PC-WH-X (X = Specify Length)
CALIFORNIA ACCENT LIGHTING, INC.
2820 E. Gretta Lane, Anaheim, CA 92806
ph. 800.921.CALI (2254) | fx. 714.535.7902 | info@calilighting.com | calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
2020.5.11 Rev 0
CONTINUOUS RUNS
1.
Insert terminal connectors into each terminal where two LED boards will be joined.
Push boards together leaving no gap.
Note: Ensure + and - terminals are aligned throughout the entire run.
1.5"
No gap between boards
1.5"
1.5"
1.
Terminal Connector
2.
Connected Boards
3.
This document is issued in strict confidence on condition that it
is not used as a basis for manufacture or sale and is not copied,
reprinted, or disclosed to a third party either wholly or in part
without the prior written consent of California Accent Lighting, Inc.
LLED8200-PC
CONNECTORS
Insert power connector or continuous connector lead wires into LED board terminals.
Insert the positive wire (red) into the terminal marked "+". Insert the neutral wire (white)
into the terminal marked "-".
Note: Ensure + and - terminals are aligned throughout the entire run.
Terminals
Power Connector or
Continuous Connector
Make connections between connectors.
Power Connector
Make connections
Perform continuity test before connecting fixture to power source.
Link:
http://www.calilighting.com/assets/pdf/lipleds/LLED8200-Continuity-Test.pdf
Connect to power source
lipLEDs
Specification Grade
Page 2 of 2
SOLDERING &
CONNECTORS
Installed connector
™
Advertisement
