A-Tach Mounts ST-1 Quick Start Manual

A-Tach # 50080
Designed for: Ford Expedition 2007-2017
For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed BEFORE a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING: AVOID extreme heat conditions. It can damage the device and the mount.
(1) See additional notes on back. Clean the area
where the mount will attach. Remove the covering
from the tape. The tape will not leave any residue if
the mount is removed in the future. Insert the
seam tool into the seam between the frame around
the radio and the padded dash top. See photo.
(3) Pull out the seam tool and insert it into the
seam at the very front of the dash top tray.
Between the tray and the padded dash top. Not the
seam of the speaker grill.
See additional instructions on the back side.
ST-1
Mobile Device Mounts
NOTICE: A-Tach Mounts will not be responsible for
any damage to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible for the use of the product and
to determine if you have the skill to attach the
product without causing damage to your vehicle or
the product.
Read all instructions and view the photos before
attaching this product.
(2) Insert the lower edge of the mount into the
seam next to the seam tool. Press the mount all
the way into the seam until the back side of the
mount touches the padded dash top.
(4) Press the mount forward and hook the front
edge of the mount into the seam next to the seam
tool. Press down on the mount to make sure the
tape makes connection to the dash panel.
A-Tach