Casio fx-350ES User Manual page 11

Specifying the Fraction Display Format
To specify this fraction
display format:
Mixed
Improper
Specifying the Statistical Display Format
Use the following procedure to turn display of the frequency (FREQ)
column of the STAT Mode STAT editor screen on or off.
To specify this:
Show FREQ Column
Hide FREQ Column
Specifying the Decimal Point Display Format
To specify this decimal
point display format:
.
Dot ( )
,
Comma ( )
• The setting you configure here is applied for calculation results
only. The decimal point for input values is always a dot (
k Initializing the Calculation Mode and Other
Settings
Performing the following procedure initializes the calculation mode
and other setup settings as shown below.
19(CLR)1(Setup)=(Yes)
This setting:
Calculation Mode
Input/Output Format
Angle Unit
Display Digits
Fraction Display Format
Statistical Display
Decimal Point
• To cancel initialization without doing anything, press A(Cancel)
instead of =.
Perform this key operation:
1Nc1(ab/c)
1Nc2(d/c)
Perform this key operation:
1Nc3(STAT)1(ON)
1Nc3(STAT)2(OFF)
Perform this key operation:
1Nc4(Disp)1(Dot)
1Nc4(Disp)2(Comma)
Is initialized to this:
COMP
MthIO
Deg
Norm1
d/c
OFF
Dot
E-9
.
).