Output And Storage Of Measurement Results - Tanita MC-780MA-N Instruction Manual

Output and Storage of Measurement Results

Data Output
Outputting measurement results via the USB or RS
The results are output to the PC immediately
after measurement is completed.
Data is output in CSV format.
•USB connector (Type-B 4 - pin female) are located
on the back of the control box.
•Please provide your own cable as necessary as none
are included.
USB cable : Type-A 4 - pin (male) - Type-B 4 - pin (male)
•You must install the necessary driver onto your PC, available download from http://www.tanita.eu
Data Storage
Data storage of measurement results
The results are saved to the SD card immedi-
ately after measurement is completed.
The icon is displayed when a valid SD card
is installed.
A new file is created on the SD card for each day.
The file is created using the measurement date and time as the file name, as shown below.
"YYYYMMDD" (year, month and date)
If "error 12" is shown in the display, this indicates that there is not enough free space left on the SD card.
You can store approximately 10,000 measurement results (weight only mode) on a 2GB SD card.
•Do not remove the SD card when it is storing or reading data.
•Do not turn off the main power when the SD card is storing or reading data.
Printing Data
Printing Measurement Results
The results are printed from the printer immediately after measurement is completed.
The number of sheets that are printed is set in .
Press the key to print additional copies.
You can print out the result if is lighted.
en
21