Hooking Up Your Tv - Magnavox MT1331B3 Owner's Manual

H U Y
OOKING P
VCR TV
TO
Connect your
B C Antenna or Cable signal to
ASIC ONNECTION
the IN FROM ANT(enna)
T he basic Antenna/Cable to
jack on the VCR.
VCR to TV connection is
shown here. If you have a Cable
Box, refer to the VCR owner's
manual for details.
300 to 75Ω
Adapter
Outdoor
VHF/UHF
Antenna
OR
Cable TV signal
C TV
ABLE
If you do not have a
C /C B
ABLE ABLE OX
Cable Box, then you're ready
to connect your Cable TV sig-
Y our Cable TV signal may be
nal to the TV. Go to step 2.
a single (75Ω) cable or a
If you have a Cable Box:
Cable Box installation. In either
Connect the Cable TV signal
case, the connection to the TV
to the IN jack on the Cable
is very easy.
Box.
Note to the Cable TV System Installer: This reminder is provided to call
the Cable TV system installer's attention to Article 820-40 of the National
Electrical Code, which provides guidelines for proper grounding - in particular,
specifying that the cable ground shall be connected to the grounding system of
the building, as close to the point of cable entry as possible.
Cable TV Signal (75Ω)
Cable TV Company
OUT
IN
Cable Box
All manuals and user guides at all-guides.com
TV (A /C
OUR NTENNA
Connect a coaxial
cable (not supplied) to
the OUT TO TV jack
on the VCR and to the
ANT(enna) IN jack on
the TV.
Back of VCR
IN FROM ANT. OUT TO TV
VCR
If you do not have a
Cable Box, connect the Cable TV
signal directly to the ANT(enna) IN
jack on the TV.
If you have a Cable Box:
Use a coaxial cable (not supplied)
to connect the OUT jack of the
Cable Box to the ANT(enna) IN
jack on the TV.
OR
Coaxial cable
- 3 -
C ) (C
ABLE ONNECTIONS
Refer to the VCR
owner's manual for other
possible connections and for
operating details.
Coaxial cable
Back of TV
ANT.IN
Back of TV
' )
ONT D
ANT.IN
S
MART
H
ELP
To select
only the channels on
your Cable system,
see Auto Install
(page 4).
If you use a Cable
Box, set the TV to
the same channel as
the CH 3/4 switch
on the back of the
Cable Box. Select
channels at the
Cable Box.