Advertisement
plus &
minus
78
Bright:
This command brightens the red, green, and blue LED's on a controller. To use the bright feature, you would send 'bright'. For
example, if you wanted to brighten the RGB LED's on a controller, you would send the command, 'bright<CR>'. LED's will be
brightened separately, and once any color reaches 100%, it will remain at 100% with each additional bright command.
All White Mode:
The controller may be set up with white LEd's on all 4 channels. The channels are labeled on the board and share the color chan-
nels, White 1 with Red, White 2 with Green, White 3 with Blue and White 4 with White You can control the white channels by
using the optional white commands. The command is the address, followed by wht followed by the channel, followed by a level.
For example, if you wanted to set White 3 to level 40% on a controller with the address of 7, you would send the command
'7wht340<CR>'.
Dim:
This command Dims the red, green, and blue LED's on a controller. To use the dim feature, you would send 'dim'. For example,
if you wanted to dim the RGB LED's on a controller, you would send the command, 'dim<CR>'. LED's will be dimmed separa-
tely, and once any color reaches 0%, it will remain at 0% with each additional dim command.
Address Query:
You can send the command "address" and the controller will return the address that it is set to.
Help:
You can send the command "help" and the controller will give you some instructions about basic operation in a small paragraph
via the serial connection.
Safety Warning: Do not open box, Rs232 controller has no serviceable parts inside. Disconnect electrical power before installing
or serviceing this equipment. This product is to be installed by a qualified person only.
Warranty
AIT warrants its products to be free from defects in material and workmanship. The exclusive remedy for this warranty is AIT factory replace-
ment of any part or parts of such product which shall within 12 months after delivery to the pirchaser be returned to AITfactory with all trans-
portation charges prepaid and which AIT determines to its satisfaction to be defective. This warranty shall not extend to defects in assembly
by other than AIT or to any article which has been repaired or altered by other than AIT or or to any article which AIT determined has been
subjected to improper use. AIT assumesno responsibility for the design characteristics od any unit or its operation in any circuit or assembly.
This warranty is in lieu of all other warranties, express or implied; all other liabilities or obligations on the part of AIT, including consequential
damages, are hereby expressly excluded.
Note: Carefully check the control for shipping damage. Report any damage to the carrier immediately. Do not attempt to operate the drive if
visible damage is evident to either the circuit or to the electronic components.
All information contained in the manual is intended to be correct, however information and data in this manual are subject to change without
notice. AIT makes no warranty of any kind with regards to this information or data. Further, AIT is not responsible for any ommissions or
errors or consequential damage caused by the user of the product. AIT reserves the right to make manufacturing changes which may not be
included in the manual.
Warning
Improper installation or operation of this control may cause injury to personnel or control failure. The control must be installed in accordance
with local, state, and national safety codes. Make certain that the power supply is disconnected before attempting to service or remove any
components. The power disconnect point is out of sight. Lock it in disconnected position and tag to prevent unexpected application of power.
Only a qualified electrician or service personnel should perform any electrical troubleshooting or maintenance.
5
Advertisement
