Table of Contents
Advertisement
5. CABLE AND CONNECTOR INSTRUCTIONS
5.1.
POWER CABLE:
The IMU power cable is supplied with an unterminated end. The cable should be secured away from any
sharp objects. Power requirement for the IMU is +11 to +24 volts DC from vehicle or an external power
source. The power input is protected by self-resetting fuse. Refer to drawing below.
Line up the keyway on the IMU's jack, labeled POWER, with the tab on the inside of the cable's
connector, sliding the connector body down until the threads make contact. Rotate the threads clockwise
until the power connector body is finger tight to the receptacle.
DO NOT OVERTIGHTEN OR DAMAGE TO THE THREADS MAY OCCUR.
FIGURE 9: POWER CABLE/CONNECTOR
- 11 -
Advertisement
Table of Contents
