Table of Contents
Advertisement
6.2.2
via IP Address
When IP address and HTTP port are known, this information is sufficient to access the
MECip-Sec web front-end by a web browser. As MECip-Sec is able to work as ETS Current
Interface, its IP address is also shown under Discovered Interfaces in ETS. For MECip-Sec, the
HTTP port can be set either to 80 or 8080.
Figure 22: Identifying MECip-Sec´s IP address with ETS
According to MECip-Sec´s pre-set IP configuration (HTTP port, IP address and DHCP), in the
URL bar has to be entered (without brackets):
Example1: DHCP is not used. With the latest ETS download the IP address was set to
192.168.1.32 and HTTP port was set to 80. In the browser´s URL bar has to be
entered "http://192.168.1.32:80/".
Example2: MECip-Sec is used with its factory default setting. This means HTTP port is
8080 and DHCP is active. The DHCP server assigned the IP address
192.168.1.201. Then, in the browser´s URL bar has to be entered
"http://192.168.1.201:8080/".
To access MECip-Sec via its IP address, the correct HTTP port must be entered in the
URL bar.
Web Front-end
http://[IP address]:[HTTP port]/
MECip
SECURE
- 33 -
Advertisement
Table of Contents
