Funkwerk TR 200 aw/ bw Operating Instructions

General notes
The operating steps described here apply for telephones without automatic line
access. For telephones with automatic line access, you must press the asterisk
key to make as internal call or to use any of the programming functions set out
here.
Some terminal devices use their own special procedures for the functions des-
cribed. Refer to the operating instructions for the telephones being used for de-
tailed information.
Safety notes
Mind the storage and operation temperatures for the device listed in the techni-
cal specifications.
Only connect the device when the permissible ambient operating temperature
has been reached.
Please note that condensation on or in the unit must be prevented when moving
from cold to warm surroundings. Only remove the unit from the package when
the permissible ambient operating temperature has been reached.
You should not make calls or connect or disconnect any lines during thunders-
torms.
Only attach the connecting cords at the connections provided.
Make sure phone cables are installed in a safe manner to prevent tripping.
Avoid the following:
Direct sunlight
Sources of heat (for example radiators)
Electronic devices (for example stereo components, office equipment or micro-
wave devices
Ingress of moisture or liquids
Aggressive fluids or vapors
Dusty environment
Do not use the unit in excessively humid rooms or hazardous locations.
Only open those sections of the device specified in the assembly / ope-
rating instructions.
Do not touch plug connectors with pointed, metal, or moist objects.
If you do not permanently mount the device or any accessories, be sure to place
it/them on a non-slip surface.
When required, clean the unit with a slightly moistened cloth.
Only use approved accessories.
Only terminals with SELV and/or which comply with ETS 300047 may be con-
nected to the unit. This regulation is fulfilled when approved terminal devices
are used as intended.
Plug-in power supply
Use only approved power plug-in units (DSA-0101F-05 UP or L15 D52 AB DDLA-
WO).
Do not use power plug-in units with visible defects or damage (fissures, cracks, etc.)
Declaration of conformity and CE mark
This device meets the requirements of the following EC directive R&TTE 1999/5/EG:
»Directive 1999/5/EC of the European Parliament and of the Council of
9 March 1999 on radio equipment and telecommunications terminal
equipment and the mutual recognition of their conformity«.
You can also request this EC declaration of conformity at the following
Internet URL: http://www.funkwerk-ec.com.
The waste container symbol with the "X" through it on the device indi-
cates that the device must be disposed of separately from normal do-
mestic waste at an appropriate waste disposal facility at the end of its
useful service life.
© 2007 Funkwerk Enterprise Communications GmbH - All rights reserved.
Reprinting of this document, even excerpts, is permitted only with the express con-
sent of the publisher and with precise source information, regardless of the media
used (mechanical or electronic).
Function descriptions included in this documentation which refer to software pro-
ducts of other manufacturers are based on the software used and valid at the date the
documentation was prepared or published. The product and company names used
in this documentation may be protected by trademarks.
Operating instructions
Funkwerk TR 200 aw/ bw
English