Advertisement
Parts Definition/ Installation/ Light Function Selection/ Volume Adjustment
■ Parts Definition/ Installation
S125DML
Lens(AS)
LED unit
Resonance chamber
(ABS)
Housing(ABS)
Rubber spacer
Flange nut
• First, remove the flange nuts from bolts and place the
product through the mounting surface holes.
• Fasten the flange nuts on the opposite side of the mounting
surface until the product is tightened securely.
Mounting Hole Specifications
• Machine holes on the mounting surface
referring to the diagram below.
Installation Environment and Protection Rating
• This product is designed for use with protection rating of IP54.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating indica-
ted(IP54), it may cause malfunction or damage to the product.
• In case of outdoor applications, install the product in the upright or horizontal position. Do not install the product upside-down or in
positions where water can potentially penetrate into the product and impact its operation.
• For further information, please visit our website (www.qlight.com).
■ Light Function Selection
Please refer to the chart below to use light function selection
•
•
switch located inside the product.
• Default function is set at steady LED. Select the desired function
for your application during installation.
■ Volume Adjustment
MAX.
Min. Ø5 CABLE ENTRY
3-Ø6 HOLES
3
ON(1)
OFF(0)
No.
1
0
0
1
0
2
1
3
1
Volume Dial
• The volume output of this
product is adjustable.
MIN.
• Turn the volume dial clockwise
to increase the volume, and
turn counter clockwise to
decrease the volume.
• There will be no sound when
the dial is put at MIN.
VOL.
PCD70
Light function
2
Steady LED
0
Flashing LED
1
Strobe LED
0
Simulated revolving/
1
flashing LED
Advertisement
