Seco SC - 010D433 Manual page 2

Copy a code:
Place the original remote and duplicator remote as close as possible (<10mm). Press and hold down at the same
time one button on the original remote and the button on duplicator remote you want to be programmed until the
LED on duplicator remote flashes four times, followed by a continuous fast blinking, indicating the programming is
completed and you are free to release the buttons. (Repeat the step for the remaining buttons you want to copy).
You are free to program in each button of the duplicator remote control a button that belongs to a different one
original remote.
Note: The best duplicating position varies depending on the original remote control you are using. You can try diff-
erent positions until the code is successfully copied. Some remotes have their antenna located to the underside of
their casing.
Code recovery:
Press and hold down button C and D until the LED start to flashing. Now all the buttons return to the last code you ha-
ve copy to them, this means that if any button has a code programmed after the memory clear process this code will
remain unchanged because this is the last programmed code.
A
B
C
D
Change code to only one button.
If you like to change the code to only one button while keeping unchanged the others you can follow the below steps.
1) Do a memory clear
2) Copy a code to button you want to change by following the respective process.
3) Do a code recovery
Now the code recovery process returns back all the codes to the other buttons, while the code of the button you just
programmed remains unchanged.
R
place
1cm
MANUAL