Table of Contents
Advertisement
Remote Control
setup
polarity balance display
1
IR transmission window
Infrared (IR) control signals are sent through this window. Aim
the
remote control
the best results, the remote should be within ±45° of a line that is
perpendicular to the faceplate of the Nº383.
At more severe angles (nearly parallel with the faceplate), try
bouncing the remote's signal off a wall or other surface instead so
as to have it enter the display window of the Nº383 at a reasonable
angle.
Alternatively, use an external infrared receiver, placed in a more
convenient location, to route the signal to the rear panel
jack.
1
standby
enter
select
volume
+
–
mute
R
MADRIGAL AUDIO LABORATORIES
INTEGRATED AMPLIFIER
Nº383
toward the Nº383 when using the remote. For
2
3
4
5
6
7
8
9
10
11
(on bottom)
ir input
25
Advertisement
Table of Contents
