Installation Guide - commercial cool CCB51GB User Manual

SET UP & USE

INSTALLATION GUIDE

1. Unpack your Beverage Cooler by removing all packaging materials
like carton, base, foams, adhesive tape, etc.
2. Remove all accessories, internal packaging material that was used to
hold shelves, etc., in place during transport.
3. Clean the remains of all adhesive tape used and remove all printed
material supplied.
4. Install the Beverage Cooler in a convenient location away from
extreme heat and cold. Allow sufficient clearance between the
Beverage Cooler and side wall so the door(s) will open without
obstruction. Beverage Cooler is not designed for recessed
installation.
5. The floor on which the Beverage Cooler should be placed must be
flat, hard, solid, and even. The Beverage Cooler should not be placed
on any soft material such as carpeting, foam, plastic, etc.
6. To level your Beverage Cooler, use the two leveling legs located on
the bottom front of your Beverage Cooler. Adjust by turning the
legs counterclockwise to raise or clockwise to lower your Beverage
Cooler. The door will close easier if the leveling legs are extended.
7. The following is the recommended minimum clearance around the
Beverage Cooler for proper air circulation:
Sides: 2" (50mm)
Top: 2" (50mm)
Proper air circulation will help your Beverage Cooler work at
maximum efficiency.
NOTE: The appliance must be correctly connected to the power supply.
It is important to keep the power cord away from the compressor at the
rear of the Beverage Cooler during operation, the compressor can reach a
high temperature and could cause serious damage to the power cord.
Care should be taken during handling, moving and use to avoid damaging
the refrigerant tubing or increasing the risk of a leak.
WARNING
CAUTION
Page 9