QuietCool IT-AF-SMT Installation Manual

Overview:
This document summarizes introductions for operating hub IT-AF-SMT. The IT-AF-SMT can
remotely control the QuietCool Attic Fans of QC Manufacturing Inc at up to three different speeds.
Key Specifications:
IT-AF-SMT (Hub):
Voltage: 120V
Frequency: 60Hz
Motor load: 1HP, 735W (Max)
Warning:
- Disconnect power at the circuit breaker before installing or servicing
- Use wires rated at least 105
- Installation/wiring must be in accordance with national and local code regulations
- Keep the enclosure cover closed at all times when not servicing.
- Cover all unused wires with a wire connector
FCC Regulations:
Supplier's Declaration of Conformity
Unique Identifier: Smart Attic Fan Control/IT-AF-SMT
Responsible Party: QC Manufacturing Inc. 26040 Ynez Rd. Temecula CA 92591
Tel:951-325-6340
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Caution: The user is cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20cm
between the radiator and any part of your body.
IT-AF-SMT Smart Attic Fan Control
Installation Guide
o C – copper only
Rev 2.0
Page 1 of 2