Installation & Use; Installtion Drilling And Lining; Mounting The Hood - Thor Kitchen TRHP Series Use & Care Manual

USE ONLY RANGE HOOD CORD CONNECTION KITS THAT
HAVE PROVIDED FOR USE WITH THIS RANGE HOOD.
Note 1:Carefully remove the plastic protective film from all
exterior surfaces of the hood, filters and duct cover prior to
installation.
Note 2: At least two people will be required to mount this
product.

INSTALLTION DRILLING AND LINING

1. Draw a vertical line on
the wall where the hood
will be installed, up to the
ceiling or as high as needed.
2. Draw a horizontal line
28-30 inches above an
electric cooktop or 30-32
inches above a gas cooktop.
3. Place chimney mounting
brackets on the wall as
shown about 1"(27mm)
from the ceiling or
upperlimit aligning the
centre(notch)with the
vertical reference line.

MOUNTING THE HOOD

1. Mount two main mounting screws into the wall along the line
that is 16"above the horizontal line.To ensure that two screws
are paralleling with horizontal line.
INSTALLATION & USE
10＂
10＂
09