Safety Notice Approved for residential type units for residential use only read these instructions and be safe. Please read these instructions completely before starting. The installation of the appliance must respect all codes. Important: Save these instruction so that you can provide the electrical inspector in your area. Safety Warning: Turn off the circuit in the electrical panel and lock front panel to connect the cord of this unit.
Page 3
do not go out immediately, LEAVE AND CALL THE FIRE DEPARTMENT. 2. NEVER PICK IP A FLAMMING PAN. You could be hurt. 3. DO NOT USE WATER, including Dish towels or wet towels-a violent steam explosion of dew may be occurred.
Electrical requirements and installation requirements Power Requirements IMPORTANT Observe all governing codes and ordinances. The customer is responsible for: Contacting an electrician installer. Check that the electrical installation is adequate and in conformance with the National Electrical Code, ANSI / NFPA 70 (latest edition *) or CSA Standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No.0-M91 (the latest edition **) of the CSA, and all codes and ordinances in your area.
Page 5
Examples and positioning possibilities ducts Follow the letter of the guidelines presented in this manual. The manufacturer declines any liability with respect to any loss, damage or fire caused by non-observance of the instructions contained in this manual. Ventilation methods: The hood is equipped with a vertical transition to remove fumes outside.
Page 6
Do not cut a joist or stud unless it is absolutely necessary to do so. If you need to cut a joist or stud, you must build a support framework, hardware supplied can secure the hood to most walls and ceilings. However, you should ask a qualified technician to check the strength of materials depending on the type of wall or ceiling.
Page 7
Clearance Training Caution: When install the hood, the height should not be too high or too low. Before the installation, please inspect the maximum height of your ceiling and bonnet.Too high, will affect the efficiency of the hood; too low, stove temperature will damage some parts of the hood. So the installation height requirement is: the distance between the bottom of the hood to the surface of the cooktop is Max 30”/ Min 27”(as figure showing)
Installation If possible, unplug the stove and move it in order to have better access to the rear wall. Otherwise, place a thick blanket on the counter and the cooking surface to protect it from damage and dirt. Select a flat surface for assembling the device.
Page 20
Installation dimension figure for 01 series, 02 series 05 series and 06 series range hood 1.Fix 6pcs screws( see figure 4) to the installation dead plate 2.Fix the installation dead plate to the wall by screws( see figure 5) 3.Use double-faced aluminum foil sealed-joint( see figure 6) 4.Power line color (black to black, white to white, green to green) (see figure 7) 5.Oil box of the hood (see figure 8) 6.Installation of clapboard filter screen (see figure 9)
Page 22
Description orders for 01 series, 03 series and 04 series range hood Automatic activation control function of the sensor: There are 5 pieces sensor buttons,1pc remote control signal lamp(remote controller included), 2 pieces stainless steel grease boxes,2 pieces stainless steel baffle filters and 2 pieces led bulbs( 12V/1.5W). A0 button: Remote control signal lamp A1 button: Power( on/off) A2 button: LED bulb...
Page 23
Bulb control Press A2 button once, turn on the lights, and again to turn off. Press A2 button or A4 button, then will not able to turn on LED light. Warning: In case of any scald, do not touch LED light, unless hood is closed or cooled. A0 button: same as above.
MAINTENANCE WARNING Before servicing or cleaning unit, switch power off at service panel and lock in access to prevent it being switched on accidentally. If the power panel can not be locked, put a prominent warning device, such as a brightly colored label. Grease filters The grease filters should be cleaned once a month or as needed.
WARRANTY This product has been manufactured by Thor Group.1335 Fortune Bay Ct,Hoffman Estates IL 60192. Thor Group disclaims all express warranties except for the following: This warranty applies to products purchased and located in the United States. Products purchased or located outside this area are excluded.
Page 26
The warranty applies to appliances purchased and used for personal, family or household purposes only. It does not cover appliances used for commercial applications.Should the appliance be sold by the original purchaser during the warranty period, the warranty shall extend to the new owner until the expiration date of the original purchaser’s warranty period.
Need help?
Do you have a question about the HRH3001U and is the answer not in the manual?
Questions and answers