Pioneer SC-85 Instructions Manual page 7

9. Using the , , , and
make the following changes:
- Set "SW" to "SW1 PLUS" for 1 Subwoofer or
- Set "SW" to "SW1+2 PLUS" for 2 Subwoofers
- Set "Front" and "Center" to "SMALL"
- Set "TFw" (Top Forward) to "Dolby Sp".
- Set "TMd (Top Middle) to "NO"
- Set "TBw" (Top Backward) to "Dolby Sp"
- Set "Surr" to "SMALL"
- Set "X.OVER" to "80Hz"
Run MCACC to calibrate the speaker outputs for the best sound
1. Place the microphone at the desired location
2. Plug the microphone into the front mic jack of
the AVR
3. Confirm and change if necessary the settings
shown below.
4. "Speaker System : 5.2.4"
5. "EQ Type : Symmetry"
6. "MCACC : M1.Memory 1"
7. "Dolby Enabled Speaker : TFw+TBw"
buttons, Select and
Note: The ceiling speakers will change to the up
firing Dolby Atmos-enabled Speakers in the
image on the right side of the screen.
10. Press the HOME MENU button to exit.
8. "SP to ceiling :" Measure the distance from top
of speaker to ceiling and enter it here using the
and buttons. Example: 6' 02"
9. "Measurement type : Expert"
10. Select "Start", press the ENTER button, and
leave the sound field area. If possible, stay in
view of the TV screen as error messages and
directions may appear.
11. After MCACC completes the calibrations, the
AVR will return to the "HOME MENU".
7