Advertisement
Disconnecting the Transducer
1. Locate the transducer below the bulkhead, just above the fuel-tank sending unit
2. Disconnect the wire harness from the transducer fitting (Box A of
3. Remove and save the transducer assembly and fitting currently installed (Box A of
4. Install the cap onto the port (Box B of
5. Connect the existing harnesses to the new wire harness (Box C of
Important:
Do not route the wire harness near moving parts.
6. Secure the wire harness using a cable tie.
Figure 1
Figure
2); torque to 79 to 98 N∙m (58 to 72 ft-lb).
Figure 2
2
(Figure
Figure
2).
Figure
Figure
2).
g212364
1).
2).
g215301
Advertisement
