Download Print this page

Toro 137-5226 Installation Instructions

Mud pump transducer relocation kit directional drill

Mud Pump Transducer Relocation Kit

DD4045 Directional Drill

Model No. 137-5226

This product contains a chemical or chemicals known to the State of California

Preparing the Machine

1. Move the machine to a level surface.

2. Shut off the engine and remove the key.

3. Set the battery-disconnect switch to the

Loose Parts

8111 Lyndale Avenue South

Bloomington, MN 55420

Proposition 65 Warning

to cause cancer, birth defects, or reproductive harm.

OFF

WARNING

CALIFORNIA

position.

Form No. 3415-957 Rev A

Installation Instructions

Original Instructions (EN)

Printed in the USA

Table of Contents

Do you have a question about the 137-5226 and is the answer not in the manual?

Page 1 Form No. 3415-957 Rev A Mud Pump Transducer Relocation Kit DD4045 Directional Drill Model No. 137-5226 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
Page 2 Disconnecting the Transducer g212364 Figure 1 1. Locate the transducer below the bulkhead, just above the fuel-tank sending unit (Figure 2. Disconnect the wire harness from the transducer fitting (Box A of Figure 3. Remove and save the transducer assembly and fitting currently installed (Box A of Figure 4.
Page 3 Installing the Transducer g215620 Figure 3 1. Remove the hose from the fitting on the rear control weldment (Box A of Figure g215621 Figure 4 2. Remove and save the fitting from the rear control weldment (Box B of Figure 3.
Page 4 8. Torque the transducer adapter to 79 to 98 N∙m (58 to 72 ft-lb) and the transducer to 46 to 57 N∙m (34 to 42 ft-lb). 9. Route the harness along the existing harnesses over to the transducer (Figure Important: Do not route the wire harness near moving parts.