Slope Safety; Floor Scraper Safety; Maintenance And Storage Safety - Toro e-Dingo 500 Operator's Manual

Slope Safety

•
Operate the machine up and down slopes with
the heavy end of the machine uphill. Weight
distribution changes with attachments. This
attachment makes the front of machine the heavy
end.
•
Raising the loader arms on a slope affects the
stability of the machine. Keep the loader arms in
the lowered position when on slopes.
•
Slopes are a major factor related to loss of control
and tip-over accidents, which can result in severe
injury or death. Operating the machine on any
slope or uneven terrain requires extra caution.
•
Establish your own procedures and rules for
operating on slopes. These procedures must
include surveying the site to determine which
slopes are safe for machine operation. Always
use common sense and good judgment when
performing this survey.
•
Slow down and use extra care on hillsides. Ground
conditions can affect the stability of the machine.
•
Avoid starting or stopping on a slope. If the
machine loses traction, proceed slowly, straight
down the slope.
•
Avoid turning on slopes. If you must turn, turn
slowly and keep the heavy end of the machine
uphill.
•
Keep all movements on slopes slow and gradual.
Do not make sudden changes in speed or
direction.
•
If you feel uneasy operating the machine on a
slope, do not do it.
•
Watch for holes, ruts, or bumps, as uneven terrain
could overturn the machine. Tall grass can hide
obstacles.
•
Use caution when operating on wet surfaces.
Reduced traction could cause sliding.
•
Evaluate the area to ensure that the ground is
stable enough to support the machine.
•
Use caution when operating the machine near the
following:
– Drop-offs
– Ditches
– Embankments
– Bodies of water
The machine could suddenly roll over if a track
goes over the edge or the edge caves in. Maintain
a safe distance between the machine and any
hazard.
•
Do not remove or add attachments on a slope.
•
Do not park the machine on a hillside or slope.

Floor Scraper Safety

•
Wear cut-resistant gloves and use caution when
installing, removing, or servicing the scraper blade.
•
Keep fingers and body parts away from the sharp
edges of the scraper blade.
•
Remove the scraper blade before moving or
changing the blade-holder assembly.
Maintenance and Storage
Safety
•
Check fasteners at frequent intervals for proper
tightness to ensure that the equipment is in safe
operating condition.
•
Refer to this Operator's Manual for important
details if you store the attachment for an extended
period of time.
•
Maintain or replace safety and instruction labels,
as necessary.
4