Black & Decker Price Pfister Parisa 534 Series Quick Start Manual page 3

1-HOLE INSTALLATION USING SINGLE POST
8
8C
8D
8E
8A
8 SINGLE POST RING INSTALLATION
Pass Single Post Ring (8A) over copper inlet / outlet tubes (8B), and press onto
Faucet Body (8C). Note: Tabs (8D) on Faucet Body (8C) must be aligned with
Grooves (8E) inside Single Post Ring (8A). To ensure this is the case, rotate
Single Post Ring (8A). When the tabs are aligned, the ring will not rotate.
9
9A
9 SINGLE POST BODY INSTALLATION
Retract Pullout Hose (9A) up through Faucet Body (9B), until the pullout hose
fi tting is fl ush with the bottom of Mounting Shank (9C). Insert Faucet Supply
Tubes (9D) and Mounting Shank (9C) through the center hole of the sink.
Note: Do not feed the Pullout Hose (9A) back down through the spout yet.
8C
8B
8A
9B
9C
9D
ENGLISH
10
10G
10F
10D
10 MOUNTING HARDWARE INSTALLATION
From underneath sink, feed Washer (10A) and Mounting Nut (10B) over
Supply Tubes (10C) and Pullout Hose (10D). Thread Mounting Nut (10B) on
to Mounting Shank (10E). Hand tighten Mounting Nut (10B) to the underside
of the sink. Using either a Phillips screwdriver, or a slotted screwdriver, evenly
tighten the Mounting Nut Retaining Screws (10F), until faucet is fi rmly secured
to sink. From above sink, feed the pullout hose (10D) down through the spout,
until Hose End (10G) docks into the spout.
11
11 WEIGHT ATTACHMENT
Your faucet includes a weight which is not required, but will help to retract
the hose during pullout operation. Insert the end of Pullout Hose (11A) into
Weight (11B).
3
10E
10D
10C
10F
10B
11A
10A
11B