Advertisement
3. AR Flush Mount Installation (above deck)
In this AR Flush Mount installation, the cable is routed out the back of the LWX-1.
This installation is the same as AR Flush Mount through-deck Installation, except
the AR Interconnect Cable is routed under the LWX-1 and out the back above the
deck instead of through the deck.
To use AR Flush Mount above-deck installation:
1.
With a pair of needle-nose pliers, break away and remove the AR
Channel Stop
2.
Insert the AR
Interconnect Cable
into cable channel on
bottom of LWX-1
3.
Ensure that the rubber
boot on the AR Inter-
connect Cable is firmly
in the AR Rubber Boot
Inset so that it is flush
with the bottom of the
AR Base.
4.
Gently form the AR Interconnect Cable from the exit of the rubber
boot up and over the rear cable exit of the AR Base
5.
Replace the AR Gasket on the AR Base, over the AR Interconnect
Cable, and then install the AR as described in "2. AR Flush Mount
through deck installation."
5
Advertisement
