Philips ITS4843B Installation Manual page 50

Chapter 2: Installing the IntelliVue Smart-hopping 1.4 GHz Core Access Point
Mounting the IntelliVue Smart-hopping Remote Antenna to a Wall (Fixed
Mount)
You can mount the IntelliVue Smart-hopping Remote Antenna (RA) to a wall using
the mounting screws and screw anchors supplied with the RA. We recommend that
you mount the RA high on the wall as close to the ceiling as possible.
To mount the 1.4 GHz IntelliVue Smart-hopping RA to a wall:
1. Using a 3/16-inch drill bit, drill two pilot holes 0.188 inches (5 mm) in diameter
at the locations shown in Figure 2-16.
2. Tap a supplied plastic screw anchor into each pilot hole until it is flush with the
wall surface.
This step is not necessary if mounting the IntelliVue Smart-hopping RA on a
wood surface.
3. Screw a supplied #6 x 1 1/4 inch self-tapping screw into each screw anchor (or
pilot hole) as shown in Figure 2-16.
Tighten each screw until a 1/16-inch (2 mm) gap remains between the screw
head and the mounting surface.
Figure 2-16: Mounting the IntelliVue Smart-hopping 1.4 GHz Remote Antenna to a
4. While holding the RA chassis with its antennas pointing down as shown in
Figure 2-16, fit the holes in the back of the RA chassis over the screw heads
2-24
Units: millimeters
inches
Wall