Charge The Battery - NEONODE N1 Manual

Remove the SD card
Important! Your Neonode must be turned off when you remove the SD card. Removing the SD card when the mobile device is turned on
may cause malfunction and loss of important settings and data.
Turn off your Neonode by pressing the on/off button (the top button on the left side, just below the screen) for about two seconds.
When you have turned off your Neonode you remove the SD card by a light pressure on the lower part of the card. The SD card will be
released and you can remove it.

Charge the battery

Please note that the battery on your Neonode can't be removed.
It takes up to 7 hours to fully charge the battery. The main power switch must be in on-position.
There are two different ways to charge the battery:
1. Use the enclosed charger. Two different plugs are enclosed, one European and one British. Choose the plug applicable in your country.
Make sure you insert the right plug correctly in the adapter before you start using the charger. To charge the battery you then insert the
charger in your Neonode's USB port and connect it to a wall socket.
2. Connect your Neonode to a computer with the enclosed USB cable. Your Neonode will charge while connected to the computer.
The text Charging will be visible on the screen when your Neonode is properly connected and charging. This text will show as long as the
device is connected to the charger/computer. Your Neonode can be charged either turned on or off. If it is turned off, you have to
disconnect your Neonode from the USB cable when finished charging before you can turn it back on.
5