Summary of Contents for AMC ALC-108A
- Page 1 ALC-108A FULLY AUTOMATIC ULTRASONIC LABEL CUTTING MACHINE USER MANUAL (VERSION 4.40) © AMC AUTOMATION CO.
-
Page 2: Table Of Contents
Sub-function table 8. Error messages Appendix 1. Cutting Examples Appendix 2. Horn Gap Adjustment Appendix 3. Ultrasonic Tuning AMC Automation Co. 11/F, Unit M, Houston Industrial Bldg 32-40 Wang Lung Street, Tsuen Wan, N.T. Hong Kong Tel: (852) 2407 0028 Fax: (852) 2408 0468 Email: sales@amc8.com... -
Page 3: Machine Layout
1. Machine layout ALC-108A Photo © AMC AUTOMATION CO. -
Page 4: Control Panel
1 when the cursor blink around the value. By holding this button pressed, value under cursor will auto increment with acceleration. Enter button: Confirm or update data value under Parameter Mode. ENTER Execute selected function under Function Mode. © AMC AUTOMATION CO. - Page 5 Press this button will move the cutter to perform a cut. Start auto button: START Press this button will start auto cut process. Stop or Exit button: Press this button will stop the auto cycle or exit the current mode STOP to idle mode. © AMC AUTOMATION CO.
-
Page 6: Line Sensor Related Buttons And Led
“Background” button longer than 1 second. If you press the “Background” button short, the machine will only get the background contrast with last selected colour. 2. If another pattern or position is selected, “L” button has to be pressed again once. © AMC AUTOMATION CO. -
Page 7: Cutting Force Setup And Adjustment Procedure
3. Cutting force setup and adjustment procedure This section was deleted for machine overview purpose. 3A. Pattern (Line) Sensor Setup Procedure This section was deleted for machine overview purpose. 4. Label setup and operation procedure © AMC AUTOMATION CO. -
Page 8: Label Counter
Machine speed index: Current machine speed index. Machine speed increase as number increase. Sensor 1:DC 2:AC DC= static sense. AC=dynamic sense Sense: 1 low 2 mid 3 high Sensor sensitivity selection Light: Auto-R-G-B 0=Auto 1=Red 2=Green 3=Blue © AMC AUTOMATION CO. -
Page 9: Function Table
Save or retrieve label setting from memory. See sub-function table All position home: Command all motors return to home position. Usually use when system report position or home error System setup: Setup display language. View each control board status. See sub-function table. © AMC AUTOMATION CO. -
Page 10: Sub-Function Table
Status 0 indicates pass, any non-zero implies some error occurred and will cause machine work improperly or lock. Please send this code to manufacturer for further investigation. Select language: Change display language. 1 = English 2 = Traditional Chinese © AMC AUTOMATION CO. P.10... -
Page 11: Error Messages
9. Error Messages This section was deleted for machine overview purpose. 8.1 Appendix 1. Cutting Examples Cutting Examples Single Cut Two Cut Center Fold Center Fold w/ Cut End Fold End Fold w/ Cut Manhattan Fold © AMC AUTOMATION CO. P.11... -
Page 12: Appendix 2. Horn Gap Adjustment
8.2 Appendix 2. Horn Gap Adjustment This section was deleted for machine overview purpose. 8.3 Appendix 3. Ultrasonic Tuning This section was deleted for machine overview purpose. © AMC AUTOMATION CO. P.12...