Page 7
Easson Easson Set Display to Zero Purpose : Set the current position for that axis to zero Example : To set the current X Axis position to zero 12.345 0.000 5.000 5.000 Inch / Metric Display Conversion Purpose : Switches between inch and metric display...
To set the current X Axis position to 45.800 mm 0.000 12.345 987.035 Easson ES-3 0.005 / 0.01 resolution display switches Purpose : Switches between 0.005mm/(0.0002") and 0.01mm(0.0004") resolution display 0.005mm 0.01mm Example 1 : Currently in display resolution, to switch to display resolution 56.785...
Page 9
The operator is then free to zero the axes or preset any dimensions into any axis in INC coordinate for relative position machining. The work piece datum ( work piece zero position ) is still retained in ABS coordinate by the ES-3. Operator can then toggle between ABS (absolute) and INC (incremental) coordinates without losing the work piece datum ( work piece zero position ).
Page 10
Easson Centre-find Purpose : ES-3 provides the centre-find function by halving the current display coordinate, so that the zero point of the work piece is located at the centre of the work piece. Example : To set the X Axis zero point at the centre of the work piece.
Page 13
(zero position) can be recovered by presetting this distance from the mark position. Operation : ES-3 provides one of the most easy-to-use datum memory function. There is no need to store the relative distance between the mark and your work datum...
Page 14
: X, Y, Z respectively step 3 : move the machine reader head across the length of the transducer until digits display in ES-3 start to count. move the machine 0.000 1.250 until...
Page 15
ES-3 starts to count, then the work piece datum is recovered move the machine 0.000 1.250 until ES-3 's digits display start run Easson ES-3 Easson ES-3 move the machine across the length of the transducer - 11 -...
Page 19
1 ( ) Turn off the ES-3. 2 ( ) Power on ES-3 once again, when "ES-3" moving in display window, please press "8" key then ES-3 enters into the RESET function. 8 8 8 8 8 8 8 8...
SETUP the DRO. Procedure: 1). Turn off the ES-3. 2). Power on the ES-3 once again, when the message "ES-3" showing in the MESSAGE WINDOW, please key immediately then the DRO ES-3 starts entering into the SETUP function.
Page 22
"LC" (linear compensation) function. 1 . d i r 2 . L C 3 . r - d Easson ES-3 Easson ES-3 : The formula of linear error compensation error value *-(1000/measuring length) = compensation value μ...